Uses 1/4" fittings

The Cool-A-Clava is designed to provide head cooling by being inserted up into the helmet and connecting to the users existing shirt.

•Choose the best method to use your Cool-A-Lava! Works well with Velcro or double-sided tape! Easy to remove using these methods.

•Cool-A-Clava uses 1/4” fittings.

•Comes with a 36” lead, one male connector fitting and one female connector fitting which will allow the you to run it down and connect it to the COOLSHIRT.

Note: If using just the Cool-A-Clava, you will need two male ends on its hoses. These ends will plug directly into the hose coming from your cooler to provide cooling to your head.

Instructions

•1) Insert Cool-A-Clava up into helmet. Coolshirt recommends using double sided tape or Velcro to hold it in place. The Cool-A-Clava should be checked for comfort before using tape or Velcro to hold in place.

•2) Once the Cool-A-Clava is in the helmet, place helmet on head just the way you normally would. Keep the hoses coming off of the product out of the way. You want the hoses to come out at the base of the helmet in the back of the head.

•3) Once in the car, route the Cool-A-Clava hoses so that they do not interfere with any other safety equipment. The hoses will be routed down to your shirt. If using only the Cool-A-Clava you can route the hoses to your hose coming off of the cooler.

•4) Plug the male fitting from the product into the female fitting of the hose coming from your cooler. Plug the female fitting from the product into one of the male fittings from your shirt. Plug the other male fitting from the shirt into the other female fitting on the hose coming from your cooler.

•5) Turn the cooler on. It will pump the water through both the shirt and Cool-A-Clava.

TMI-CST-1504-0001